Everything you need to know when you are installing components in your CMT520.
Q1: Fan is running, light is on, but RGB effect of the fan cannot be switched? (when Motherboard is not synced)
Q2: How to change the lighting effect on CMT520?
Press the RGB button on the I/O control panel.
The controller board provides 6 different lighting effects:
· Single Color
· 7-color cycling (Flash)
· 3-color cycling (Flash 3 Colors),
· Breathing Mode· No Light.
Q3: How to sync CMT520 RGB lighting effect with your motherboard?
STEP 1: Shut down the PC and turn off the power.
STEP 2: Open the side cover, locate the 12V RGB(4PIN) connector on the motherboard (see Fig. c),connect the RGB cable of the controller board with the motherboard as shown in Fig. d. Make sure the 4 wires are correctly connected to +, G, R, and B respectively (△mark on the connector indicates the positive +)
STEP 3: Lock up the side cover and start the PC.Download and install the sync software provided by the motherboard. Press and hold the RGB button on the I/O control panel of the case for 3 seconds to switch over to motherboard sync mode. Verify if the installation of RGB fan is detected by the software. Now you are able to control the RGB fan’s lighting effect via the software.
STEP 4: Pressing and holding this button again to switch back to controller board mode.
STEP 5: Contact FSP customer service if lighting effect still cannot be synchronized with the motherboard.